Plastic preform warming bulb

Sun, 21 Jun 2026 05:02:37 +0800

On the blow molding line, preform temperature isn’t a nice-to-have—it’s the line between steady output and scrap. When the warming bulb in your heating tunnel starts lagging, you see uneven stretch, crystallized shoulders, and the reject rate spikes. We make infrared preform warming bulbs that drop in 1:1 with OEM lamps—same electricals, same mechanical fit—so you stop chasing temperature drift and get back to repeatable cycles. What matters, technically We run short-wave infrared halogen emitters in a quartz envelope, chosen for fast response and stable radiant output inside the heating tunnel. Typical ratings are 1000–1500 W at 120/230 V, with tight filament geometry and standard R7s base connections so the lamp drops straight into existing sockets. The spectrum is tuned to couple efficiently into PET preforms, heating the wall quickly without dumping too much heat on the surface. In practice, that means quicker recovery to setpoint after a jar change and less cavity-to-cavity variation. On Sidel, Krones, SIPA, Husky, SACMI, and Nissei ASB blow molders, the heating zone is only as consistent as the emitters. Our bulbs deliver repeatable radiant energy, which translates into more consistent preform stretch and fewer pinholes, thin walls, or whitening defects. You also see energy use drop, because the emitter comes up fast and holds stable output, so the tunnel doesn’t have to be overdriven to compensate. Replacement is simple—no rewiring, no retuning the whole oven—just pull the old, plug in the new, and get back to spec. Here’s the thing: match the lamp to the machine—voltage, wattage, length, and connector type. If the reflector or socket is tired, you can still get uneven heating even with a correct lamp, because reflectance and contact resistance degrade over time. Check alignment and clean the reflector when you swap bulbs. If you don’t, hot spots and output loss will creep right back. Also confirm your heating controller’s dimming/firing method is compatible with halogen drivers—otherwise, you’ll stress the lamp prematurely.

Plastic on Core Infrared Heating Technology

Plastic preform warming bulb